Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WIPER / WASHER
WIPER ECU - INSTALLATION
- HINT:
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
| 1. INSTALL WINDSHIELD WIPER ECU |
Install the windshield wiper ECU with the screw.
Connect the 2 connectors.
| 2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL |
Connect the connector.
Attach the 3 claws to install the lower No. 2 instrument panel finish panel.
Install the 4 bolts.
| 3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB |
Attach the 2 claws to install the instrument panel box door knob.
| 4. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Attach the 6 claws to install the No. 3 instrument cluster finish panel garnish.
| 5. INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag) |
Attach the 4 claws to install the lower instrument panel.
Install the 2 bolts.
| 6. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag) |
Connect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Attach the 4 claws to install the front passenger side knee airbag.
Install the 4 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm, 7 ft.*lbf}
| 7. INSTALL FRONT DOOR SCUFF PLATE RH |
- HINT:
- Use the same procedures described for the LH side.
| 8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover) |
Attach the 4 claws to install the No. 2 instrument panel under cover.
| 9. INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch) |
Connect the connector.
Attach the 6 claws to install the instrument side panel.
| 10. INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch) |
Attach the 6 claws to install the instrument side panel.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 12. CHECK SRS WARNING LIGHT |
()