Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WIPER / WASHER
WASHER MOTOR (for Rear Side) - INSTALLATION
| 1. INSTALL REAR WASHER MOTOR AND PUMP ASSEMBLY |
Install the washer motor together with the gasket in the direction shown in the illustration.
- HINT:
- Make sure the gasket is positioned as shown in the illustration.
| 2. INSTALL WINDSHIELD WASHER JAR ASSEMBLY |
Temporarily install the windshield washer jar with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration to install the windshield washer jar.
- Torque:
- 8.0 N*m{ 82 kgf*cm, 71 in.*lbf}
w/ Headlight Cleaner System:
Connect the 2 connectors.
Attach the clamp.
Connect the headlight cleaner hose to the headlight cleaner motor and pump.
w/o Headlight Cleaner System:
Connect the connector.
Attach the clamp.
| 3. INSTALL WASHER INLET SUB-ASSEMBLY |
Install the washer inlet with the clip.
| 4. FILL WINDSHIELD WASHER JAR AND PUMP ASSEMBLY WITH WASHER FLUID |
Connect the washer hose to the windshield washer motor and pump, and fill the washer jar with washer fluid.
| 5. INSTALL FRONT FENDER LINER LH |
Install the fender liner with the 12 clips and 2 new grommets.
Using a T30 "TORX" socket, install the 2 screws.
Install the 2 screws.
| 6. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY LH |
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
If reusing the rocker panel moulding:
Clean the rocker panel moulding.
Using a heat light, heat the rocker panel moulding.
Remove the double-sided tape from the rocker panel moulding.
Wipe off any tape adhesive residue with cleaner.
Apply new double-sided tape to the rocker panel moulding, as shown in the illustration.
Install the rocker panel moulding.
Using a heat light, heat the vehicle body and rocker panel moulding.
Remove the peeling paper from the face of the rocker panel moulding.
- HINT:
- After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the 10 clips to install the rocker panel moulding.
Install the 8 side mudguard retainers and screw.
| 7. INSTALL SIDE STEP ASSEMBLY LH |
Install the side step with the 6 bolts.
- Torque:
- 30 N*m{ 306 kgf*cm, 22 ft.*lbf}
| 8. INSTALL FRONT FENDER MUDGUARD LH |
Remove the 8 side mudguard retainers and screw.
Detach the 10 clips and remove the rocker panel moulding.