Tail Gate Closer System - How To Proceed With Troubleshooting

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - DOOR / HATCH


TAIL GATE CLOSER SYSTEM - HOW TO PROCEED WITH TROUBLESHOOTING

  • HINT:
Use these following procedures to troubleshoot the tail gate closer system.
*: Use the intelligent tester.

1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
  • Standard voltage:
  • 11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

Use the intelligent tester to check if the CAN communication system is functioning normally.

Result
ResultProceed to
CAN DTC is not outputA
CAN DTC is output (for LHD)B
CAN DTC is output (for RHD)C
B.
GO TO CAN COMMUNICATION SYSTEM ()
C.
GO TO CAN COMMUNICATION SYSTEM ()
A
4.CHECK DTC OUTPUT*

Starting with the lower tail gate closed, open and close the lower tail gate 6 times.

Check for DTCs ().

Clear the DTCs ().

Starting with the lower tail gate closed, open and close the lower tail gate 6 times.

Recheck for DTCs ().

Result
ResultProceed to
DTC is not outputA
DTC is outputB
B.
GO TO DIAGNOSTIC TROUBLE CODE CHART ()
A
5.PROBLEM SYMPTOMS TABLE

Refer to the Problem Symptoms Table ().

Result
ResultProceed to
Fault is not listed in problem symptoms tableA
Fault is listed in problem symptoms tableB
B.
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
A
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

Operation Check ().

Terminals of ECU ().

Data List / Active Test ().

NEXT
7.REPAIR OR REPLACE
NEXT
8.CONFIRMATION TEST
NEXT
END