Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - LIGHTING EXT
SIDE TURN SIGNAL LIGHT ASSEMBLY (for Outer Rear View Mirror) - INSTALLATION
- HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
| 1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
Connect the connector.
Install the light with the 3 screws.
| 2. INSTALL OUTER MIRROR COVER LH |
Install the outer mirror cover.
Insert the rib on the outer edge of the cover into the groove of the mirror body.
- NOTICE:
- Do not scratch the turn light.
| *1 | Rib |
While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.
Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.
Check that there is no gap between the cover and mirror body.
- HINT:
- If there is a gap between the cover and body, noise will occur during driving.
| 3. INSTALL OUTER MIRROR LH |
w/ EC Mirror:
Connect the connector.
w/ Mirror Heater:
Connect the 2 connectors.
Attach the 4 claws to install the outer mirror LH.
| 4. INSTALL OUTER REAR VIEW MIRROR LH |
()