Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WIPER / WASHER
RELAY (w/ Headlight Cleaner System) - ON-VEHICLE INSPECTION
| 1. INSPECT HEADLIGHT CLEANER CONTROL RELAY |
w/o Washer Linked Operation:
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 6 (B) - 4 (E) Battery voltage is not applied between terminals 3 (IG) and 2 (H) 10 kΩ or higher Battery voltage is applied between terminals 3 (IG) and 2 (H) Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists)
If the result is not as specified, replace the headlight cleaner control relay.
| *a | Component without harness connected (Headlight Cleaner Control Relay) |
w/ Washer Linked Operation:
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 6 (B) - 4 (E) Battery voltage not applied 10 kΩ or higher Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 2 (H)
Battery negative (-) → Terminal 4 (E)Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 1 (HDLO)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)
If the result is not as specified, replace the headlight cleaner control relay.
| *a | Component without harness connected (Headlight Cleaner Control Relay) |