Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WIPER / WASHER
REAR WIPER MOTOR - REMOVAL
| 1. REMOVE CENTER BACK DOOR GARNISH |
Detach the 5 clips and 4 claws, and remove the center back door garnish.
| 2. REMOVE BACK DOOR SIDE GARNISH LH |
Detach the 3 clips and 2 claws, and remove the back door side garnish LH.
| 3. REMOVE BACK DOOR SIDE GARNISH RH |
w/o Power Back Door:
- HINT:
- Use the same procedure described for the LH side.
w/ Power Back Door:
Detach the clip and 4 claws, and remove the back door side garnish RH.
| 4. REMOVE ASSIST GRIP (for Face to Face Seat Type) |
Remove the 2 screws and assist grip.
| 5. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type) |
Using a screwdriver, detach the 4 claws and remove the No. 2 back door service hole cover.
Disconnect connector.
| 6. REMOVE DOOR OPENING SWITCH SUB-ASSEMBLY (for Face to Face Seat Type) |
Detach the 2 claws and remove the door opening switch sub-assembly.
| 7. REMOVE BACK DOOR GARNISH |
Using a screwdriver, detach the 14 clips and remove the back door garnish.
- HINT:
- Tape the screwdriver tip before use.
| 8. REMOVE REAR WIPER ARM |
Open the cover.
Remove the nut and rear wiper arm.
| 9. REMOVE REAR WIPER MOTOR GROMMET |
Detach the rear wiper motor grommet.
| 10. REMOVE REAR WIPER MOTOR ASSEMBLY |
Disconnect the connector.
Remove the 3 bolts and rear wiper motor assembly.