Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
REAR DOOR WINDOW FRAME MOULDING - INSTALLATION
- HINT:
- Standard Heating Temperature:
Item Temperature Vehicle Body 40 to 60°C (104 to 140°F) Window Frame Moulding 20 to 30°C (68 to 86°F)
- NOTICE:
- Do not heat the vehicle body and window frame moulding excessively.
| 1. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH |
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body surface.
Wipe off any tape adhesive residue with cleaner.
Install a new window frame moulding.
Using a heat light, heat a new window frame moulding and the vehicle body surface.
Remove the peeling paper from the face of the window frame moulding.
- HINT:
- After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the clip and double-sided tape to install the window frame moulding.
- HINT:
- Press the window frame moulding firmly to install it.
| 2. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH |
Attach the claw to install the belt moulding.
| 3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH |
Slide the rear door glass sub-assembly LH as shown in the illustration to install it.
| 4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH |
Install the rear door quarter window glass LH together with the rear door quarter window weatherstrip LH in the direction indicated by the arrow in the illustration.
| 5. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH |
Install the rear door rear lower window frame sub-assembly LH with the 2 bolts and screw.
| 6. INSTALL REAR DOOR GLASS RUN LH |
Install the rear door glass run LH.
| 7. INSTALL REAR DOOR SERVICE HOLE COVER LH |
Apply butyl tape to the door.
Pass the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH through a new rear door service hole cover LH.
- NOTICE:
Connect the 2 connectors.
Attach the 6 clamps.
Install the bolt as shown in the illustration.
- Torque:
- 8.4 N*m{ 86 kgf*cm, 74 in.*lbf}
| 8. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH |
Install the rear inner door glass weatherstrip LH to the door panel.
| 9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
Connect the connector.
Connect the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH to the rear door inside handle sub-assembly LH.
Attach the 4 claws and 9 clips to install the rear door trim board sub-assembly LH.
Install the 3 screws.
| 10. INSTALL ASSIST GRIP COVER LH |
Attach the 9 claws to install the assist grip cover LH to the rear door trim board sub-assembly LH.
| 11. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH |
Connect the connector.
Attach the 7 claws to install the armrest base panel.
| 12. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH |
Attach the 4 claws to install the rear door inside handle bezel LH.
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().