Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
REAR DOOR OUTSIDE MOULDING - REMOVAL
- HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
| 1. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH |
Put protective tape around the rear door outside moulding sub-assembly LH.
| *1 | Protective Tape |
Using a moulding remover, detach the 3 clamps and 7 clips, and remove the rear door outside moulding sub-assembly LH.
Remove any clips remaining on the door panel.
- NOTICE:
- Be careful not to allow any clips or pieces of clips to fall inside the door panel.