INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

INSTALL REAR DOOR QUARTER WINDOW GLASS LH

INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

INSTALL REAR DOOR GLASS RUN LH

INSTALL REAR DOOR SERVICE HOLE COVER LH

INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH

INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

INSTALL ASSIST GRIP COVER LH

INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Attach the claw to install the belt moulding.

Slide the rear door glass sub-assembly LH as shown in the illustration to install it.

Install the rear door quarter window glass LH together with the rear door quarter window weatherstrip LH in the direction indicated by the arrow in the illustration.

Install the rear door rear lower window frame sub-assembly LH with the 2 bolts and screw.

Install the rear door glass run LH.

Apply butyl tape to the door.

Pass the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH through a new rear door service hole cover LH.

• NOTICE:

Connect the 2 connectors.

Attach the 6 clamps.

Install the bolt as shown in the illustration.

• Torque:
• 8.4 N*m{ 86 kgf*cm, 74 in.*lbf}

Install the rear inner door glass weatherstrip LH to the door panel.

Connect the connector.

Connect the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH to the rear door inside handle sub-assembly LH.

Attach the 4 claws and 9 clips to install the rear door trim board sub-assembly LH.

Install the 3 screws.

Attach the 9 claws to install the assist grip cover LH to the rear door trim board sub-assembly LH.

Connect the connector.

Attach the 7 claws to install the armrest base panel.

Attach the 4 claws to install the rear door inside handle bezel LH.