Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
REAR BUMPER (w/ Towing Hitch) - REASSEMBLY
| 1. INSTALL REAR NO. 2 STEP COVER |
Attach the 4 claws to install the rear No. 2 step cover.
Install the 2 screws and 2 clips.
| 2. INSTALL REAR LOWER BUMPER COVER |
Install the rear lower bumper cover with the clip.
| 3. INSTALL REFLEX REFLECTOR ASSEMBLY LH |
Attach the claw to install the reflex reflector assembly LH.
Install the 2 nuts.
| 4. INSTALL REFLEX REFLECTOR ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 5. INSTALL REAR BUMPER ENERGY ABSORBER |
Attach the 8 claws to install the rear bumper energy absorber.
| 6. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System) |
- HINT:
- Use the same procedure to install the No. 1 ultrasonic sensor retainer on the other side.
Align the keyhole and protrusion as shown in the illustration.
| *a | Protrusion |
| *b | Keyhole |
- NOTICE:
Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor retainer.
Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.
- HINT:
- The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner is opposite that of the image shown in the illustration.
Attach the 2 claws to install the No. 1 ultrasonic sensor retainer.
| 7. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System) |
- HINT:
- Use the same procedure to install the No. 2 ultrasonic sensor retainer on the other side.
Align the keyhole and protrusion as shown in the illustration.
| *a | Protrusion |
| *b | Keyhole |
- NOTICE:
Do not damage the bumper with the protrusion when installing the No. 2 ultrasonic sensor retainer.
Securely install the No. 2 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.
Attach the 2 claws to install the No. 2 ultrasonic sensor retainer.
| 8. INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System) |
- HINT:
- Use the same procedure for all No. 1 ultrasonic sensors.
Attach the 2 claws to install the No. 1 ultrasonic sensor.
- NOTICE:
- Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.
| 9. INSTALL NO. 2 FRAME WIRE (w/ TOYOTA Parking Assist-sensor System) |
Attach the 12 clamps to install the No. 2 frame wire.
Connect the 4 connectors.