Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
REAR BUMPER (w/ Towing Hitch) - DISASSEMBLY
| 1. REMOVE NO. 2 FRAME WIRE (w/ TOYOTA Parking Assist-sensor System) |
Disconnect the 4 connectors.
Detach the 12 clamps and remove the No. 2 frame wire.
| 2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System) |
Detach the 2 claws and remove the No. 1 ultrasonic sensor.
- HINT:
Use the same procedure for all No. 1 ultrasonic sensors.
The illustration shows the No. 1 ultrasonic sensor for the RH corner and back sensor LH and RH. The installation position of the No. 1 ultrasonic sensor for the LH corner is on the opposite side.
| 3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System) |
Detach the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.
- HINT:
Use the same procedure to remove the No. 1 ultrasonic sensor retainer on the other side.
The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner is opposite that of the image shown in the illustration.
| 4. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System) |
Detach the 2 claws and remove the No. 2 ultrasonic sensor retainer from the rear bumper cover.
- HINT:
- Use the same procedure to remove the No. 2 ultrasonic sensor retainer on the other side.
| 5. REMOVE REAR BUMPER ENERGY ABSORBER |
Detach the 8 claws and remove the rear bumper energy absorber.
| 6. REMOVE REFLEX REFLECTOR ASSEMBLY LH |
Remove the 2 nuts.
Detach the claw and remove the reflex reflector assembly LH.
| 7. REMOVE REFLEX REFLECTOR ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 8. REMOVE REAR LOWER BUMPER COVER |
Remove the clip and rear lower bumper cover.
| 9. REMOVE REAR NO. 2 STEP COVER |
Remove the 2 screws and 2 clips.
Detach the 4 claws and remove the rear No. 2 step cover.