DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
READ VALUE USING INTELLIGENT TESTER (PBD CLOSE SW)
INSPECT BACK DOOR CONTROL SWITCH
CHECK HARNESS AND CONNECTOR (BACK DOOR CONTROL SWITCH - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND)
POWER BACK DOOR SYSTEM - Door Control Switch Circuit
DESCRIPTION
The back door control switch only turns on while the switch is being pressed, and turns off when the back door control switch is released.
When the back door control switch is on, a power back door close request signal is input to the power back door unit assembly (power back door ECU) to close the back door.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.READ VALUE USING INTELLIGENT TESTER (PBD CLOSE SW) |
Check the Data List for proper functioning of the back door control switch ().
Back Door| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PBD Close SW | Back door control switch signal / ON or OFF | ON: Back door control switch on
OFF: Back door control switch off | - |
- OK:
- The display is as specified in the normal condition.
| OK | |
| |
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE ()
|
|
| 2.INSPECT BACK DOOR CONTROL SWITCH |
Remove the back door control switch ().
Inspect the back door control switch ().
| | REPLACE BACK DOOR CONTROL SWITCH ()
|
|
|
| 3.CHECK HARNESS AND CONNECTOR (BACK DOOR CONTROL SWITCH - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND) |
Disconnect the S25 back door control switch connector.
Disconnect the L52 power back door unit assembly (power back door ECU) connector.
Measure the resistance of the wire harness side connectors.
- Standard Resistance:
| Tester Connection | Condition | Specified Condition |
| S25-3 (MSW) - L52-4 (DS1) | Always | Below 1 Ω |
| S25-4 (E) - Body ground | Always | Below 1 Ω |
| S25-3 (MSW) - Body ground | Always | 10 kΩ or higher |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK | |
| |
| REPLACE POWER BACK DOOR UNIT ASSEMBLY (POWER BACK DOOR ECU) ()
|
|