REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

REMOVE DOOR ASSIST GRIP COVER LH

REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY

Detach the clip and claw, and remove the front door lower frame bracket garnish LH.

Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.

• HINT:

• Tape the screwdriver tip before use.

Using a moulding remover, detach the 5 claws.

Disconnect the connector and remove the armrest base panel.

Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.

Remove the 3 screws.

Remove the 13 clips.

Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

• HINT:

• Make sure that the pin labeled A in the illustration is detached from the door panel.

Disconnect the connector.

Disconnect the 2 cables from the front door inside handle sub-assembly LH.

Disconnect the 2 connectors.

Remove the 2 screws and outer mirror control ECU.