REMOVE UPPER RADIATOR SUPPORT SEAL

REMOVE FRONT FENDER MAIN SEAL LH (for LHD)

REMOVE FRONT FENDER MAIN SEAL RH (for RHD)

REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY (w/ Winch)

REMOVE RADIATOR GRILLE ASSEMBLY

REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

REMOVE HOOD LOCK CONTROL CABLE COVER

REMOVE HOOD LOCK NUT CAP

REMOVE HOOD LOCK ASSEMBLY

REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

Remove the 7 clips and radiator support seal.

Using a screwdriver, detach the 3 clips and remove the fender main seal.

• HINT:

• Tape the screwdriver tip before use.

Using a screwdriver, detach the 3 clips and remove the fender main seal.

• HINT:

• Tape the screwdriver tip before use.

Detach the 2 claws.

Detach the 3 guides and remove front bumper winch cover sub-assembly.

Put protective tape around the radiator grille assembly.

Remove the 3 screws.

Detach the 2 clips and 8 claws, and remove the radiator grille assembly.

w/ Wide View Front Monitor System:

Disconnect the sensor connector.

Remove the 3 bolts and sensor.

Remove the 3 screws.

Detach the claw and remove the cable cover.

Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

• HINT:

• Tape the screwdriver tip before use.

Remove the 2 bolts and nut.

Remove the hood lock.

Disconnect the connector.

Disconnect the hood lock control cable.

Detach the 2 claws.

Disconnect the hood lock control cable and remove the hood lock lever.

Using a screwdriver, disconnect the clamps shown in the illustration.

• HINT:

• Tape the screwdriver tip before use.

Pull the cable from the engine room and remove it.

Using a screwdriver, disconnect the clamps shown in the illustration.

• HINT:

• Tape the screwdriver tip before use.

Pull the cable from the engine room and remove it.