Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - LIGHTING EXT
HAZARD WARNING SWITCH - REMOVAL
- HINT:
Use the same procedures for the RHD and LHD.
The procedures listed below are the LHD side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY |
Detach the 8 claws and remove the opening cover.
| 3. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY |
Place protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover, detach the 6 claws.
Disconnect the connector and remove the No. 3 instrument panel register.
| 4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY |
Place protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover, detach the 6 claws.
Disconnect the connector and remove the No. 4 instrument panel register.
| 5. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver) |
Remove the 2 screws and 2 bolts.
Disconnect the connectors and remove the radio receiver.
| 6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver) |
Detach the 10 claws.
Disconnect the connector and remove the No. 1 center instrument cluster finish panel.
| 7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
Detach the 2 claws and remove the hazard warning switch.