Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WIPER / WASHER

FRONT WIPER MOTOR - INSPECTION

1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)
Front Wiper Motor - Inspection. WIPER / WASHER. Land Cruiser URJ200  URJ202 GRJ200 VDJ200

Check the LO operation.

Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

  • OK:
  • Measurement ConditionSpecified Condition
    Battery positive (+) → Terminal 1 (+1)
    Battery negative (-) → Terminal 5 (E)
    Motor operates at low speed

If the result is not as specified, replace the windshield wiper motor assembly.


Check the HI operation.

Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

  • OK:
  • Measurement ConditionSpecified Condition
    Battery positive (+) → Terminal 4 (+2)
    Battery negative (-) → Terminal 5 (E)
    Motor operates at high speed

If the result is not as specified, replace the windshield wiper motor assembly.


Check the automatic stop operation.

Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

Using SST, connect terminals 3 (+S) and 1 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

  • SST
  • 09843-18040

Check that the motor stops automatically at the automatic stop position.

  • OK:
  • Automatically stops.

If the result is not as specified, replace the windshield wiper motor assembly.


2. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)
Front Wiper Motor - Inspection. WIPER / WASHER. Land Cruiser URJ200  URJ202 GRJ200 VDJ200

Check the LO operation.

Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

  • OK:
  • Measurement ConditionSpecified Condition
    Battery positive (+) → Terminal 5 (+1)
    Battery negative (-) → Terminal 4 (E)
    Motor operates at low speed

If the result is not as specified, replace the windshield wiper motor assembly.


Check the HI operation.

Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

  • OK:
  • Measurement ConditionSpecified Condition
    Battery positive (+) → Terminal 3 (+2)
    Battery negative (-) → Terminal 4 (E)
    Motor operates at high speed

If the result is not as specified, replace the windshield wiper motor assembly.


Check the automatic stop operation.

Connect the positive (+) battery lead to terminal 5 (+1) of the connector and the negative (-) battery lead to terminal 4 (E). With the motor operating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

Using SST, connect terminals 1 (+S) and 5 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

  • SST
  • 09843-18040

Check that the motor stops automatically at the automatic stop position.

  • OK:
  • Automatically stops.

If the result is not as specified, replace the windshield wiper motor assembly.