Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM

FRONT BUMPER (w/ Winch) - REASSEMBLY

  • HINT:
A bolt without a torque specification is shown in the standard bolt chart ().
When installing the front bumper protector, heat the front bumper surface using a heat light.
  • Standard Heating Temperature:
  • ItemTemperature
    Front Bumper20 to 30°C (68 to 86°F)
  • NOTICE:
  • Do not heat the front bumper excessively.
1. INSTALL WINCH CONTROL WIRE
Front Bumper (W/ Winch) - Reassembly. EXTERIOR PANELS / TRIM. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Install the winch control wire with the 2 nuts.

  • Torque:
  • 5 N*m{ 51 kgf*cm, 45 in.*lbf}
2. INSTALL FRONT LICENSE PLATE BRACKET (w/ Bracket)

Install the front license plate bracket with the 2 nuts.

3. INSTALL FRONT NO. 2 BUMPER PROTECTOR

Clean the front bumper cover surface.

Using a heat light, heat the front bumper cover surface.

Remove the double-sided tape from the front bumper cover.

Wipe off any tape adhesive residue with cleaner.

Front Bumper (W/ Winch) - Reassembly. EXTERIOR PANELS / TRIM. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Install new front No. 2 bumper protector.

Remove the peeling paper from the face of new front No. 2 bumper protector.

  • HINT:
  • After removing the peeling paper, keep the exposed adhesive free from foreign matter.

Install the 2 front No. 2 bumper protectors as shown in the illustration.

4. INSTALL LOWER RADIATOR GRILLE LH

Attach the 6 claws to install the lower radiator grille LH.

5. INSTALL LOWER RADIATOR GRILLE RH
  • HINT:
  • Use the same procedure described for the LH side.
6. INSTALL FRONT BUMPER HOLE COVER LH (w/ Fog Light)

Attach the 5 claws to the front bumper hole cover LH.

Install the 2 screws and 2 retainers.

7. INSTALL FRONT BUMPER HOLE COVER RH (w/ Fog Light)
  • HINT:
  • Use the same procedure described for the LH side.
8. INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)

Attach the 5 claws to the front bumper hole cover LH.

Install the screw and 2 retainers.

9. INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)
  • HINT:
  • Use the same procedure described for the LH side.
10. INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)

Connect the connector.

Attach the 2 guides and install the fog light assembly LH.

Install the 2 screws.

11. INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)
  • HINT:
  • Use the same procedure described for the LH side.
12. INSTALL FRONT BUMPER INNER BRACKET (w/ Fog Light)

Attach the 3 claws and install the front bumper inner bracket.

13. INSTALL NO. 4 ENGINE ROOM WIRE (w/ Fog Light)

Attach the 11 clamps to install the No. 4 engine room wire.

Connect the 2 connectors.

EXTERIOR PANELS / TRIM
Land Cruiser URJ200 URJ202 GRJ200 VDJ200
FRONT BUMPER w/ Winch