DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
READ VALUE USING INTELLIGENT TESTER (BACK DOOR LOCK)
INSPECT BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)
CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND)
DTC B2251 Back Door Closer Switch Malfunction
DESCRIPTION
The power back door unit assembly (power back door ECU) inputs signals from the latch switch, closer position switch and back door courtesy switch, which are built into the back door lock assembly. Based on these switch signals, the latch position of the back door lock assembly is determined.
| DTC Code | DTC Detection Condition | Trouble Area |
| B2251 |
While back door closer is operating, malfunction is detected in position information from each switch within specified amount of time |
Back door lock assembly
Harness or connector
Power back door unit assembly (power back door ECU)
|
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.READ VALUE USING INTELLIGENT TESTER (BACK DOOR LOCK) |
Check the Data List for proper functioning of each switch ().
Back Door| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Half Latch SW | Latch switch signal / ON or OFF | ON: Latch switch is on
OFF: Latch switch is off | - |
| Courtesy SW | Back door courtesy switch signal / ON or OFF | ON: Back door courtesy switch is on
OFF: Back door courtesy switch is off | - |
- OK:
- The display is as specified in the normal condition.
| OK | |
| |
| REPLACE POWER BACK DOOR UNIT ASSEMBLY (POWER BACK DOOR ECU) ()
|
|
| 2.INSPECT BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH) |
Remove the back door lock assembly ().
Inspect the back door lock assembly ().
| | REPLACE BACK DOOR LOCK ASSEMBLY ()
|
|
|
| 3.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND) |
Disconnect the S22 back door lock assembly connector.
Disconnect the L52 power back door unit assembly (power back door ECU) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
| Tester Connection | Condition | Specified Condition |
| S22-5 (CLS) - L52-22 (HAF) | Always | Below 1 Ω |
| S22-3 (CTY) - L52-20 (FUL) | Always | Below 1 Ω |
| S22-4 (E) - Body ground | Always | Below 1 Ω |
| S22-5 (CLS) - Body ground | Always | 10 kΩ or higher |
| S22-3 (CTY) - Body ground | Always | 10 kΩ or higher |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK | |
| |
| REPLACE POWER BACK DOOR UNIT ASSEMBLY (POWER BACK DOOR ECU) ()
|
|