Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
BACK DOOR GARNISH (for Double Swing Out Type) - REMOVAL
1. REMOVE ASSIST GRIP LH |
Using a screwdriver, detach the 2 claws and open the 2 covers.
- HINT:
- Tape the screwdriver tip before use.
*1 | Protective Tape |
Remove the 2 bolts and assist grip.
2. REMOVE DOOR INSIDE HANDLE BEZEL LH |
Detach the claw and open the cover.
Remove the screw.
Using a screwdriver, detach the 2 claws.
- HINT:
- Tape the screwdriver tip before use.
*1 | Protective Tape |
Detach the guide and remove the door inside handle bezel in the direction indicated by the arrow in the illustration.
3. REMOVE BACK DOOR TRIM PANEL ASSEMBLY LH |
Detach the 10 clips and remove the back door trim panel.
4. REMOVE REAR ASSIST GRIP REINFORCEMENT LH |
Remove the 3 bolts and rear assist grip reinforcement.
5. REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY LH |
Remove the screw.
Detach the guide and remove the back door inside handle in the direction indicated by the arrow in the illustration.
Disconnect the 2 links from the back door inside handle.
6. REMOVE BACK DOOR SERVICE HOLE COVER LH |
Disconnect the 2 connectors and detach the 3 clamps.
Pull out the 2 links and wire harness from the back door service hole cover, and then remove the back door service hole cover.
- HINT:
- Remove any remaining butyl tape from the back door panel.
7. REMOVE BACK DOOR OUTSIDE HANDLE |
Detach the guide and disconnect the cable.
Remove the 2 bolts and back door outside handle.
8. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
Detach the clamp and disconnect the connector.
Detach the grommet, and then pull out the wire harness from the back door panel.
*1 | Grommet |
Detach the 10 clips and remove the back door outside garnish.