Height Control Sensor (For Front Side) - Adjustment

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SUSPENSION CONTROL

HEIGHT CONTROL SENSOR (for Front Side) - ADJUSTMENT

1. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY
  • NOTICE:
Make adjustments from the link that deviates the most from the specified vehicle height value.
When the front and rear are at the same level, make adjustments from the front first.
If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.
Height Control Sensor (For Front Side) - Adjustment. SUSPENSION CONTROL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.

  • HINT:
  • When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).

Tighten the nut of the height control sensor link.

  • Torque:
  • 5.6 N*m{ 57 kgf*cm, 50 in.*lbf}
2. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

Perform the vehicle height offset calibration ().

3. PERFORM ZERO POINT CALIBRATION OF G SENSOR

Perform the zero point calibration of G sensor ().

4. ADJUST FRONT WHEEL ALIGNMENT

Adjust the front wheel alignment ().

5. ADJUST HEADLIGHT ASSEMBLY

for Standard:


Adjust the headlight ().

for HID Headlight:


Adjust the headlight ().