Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SUSPENSION CONTROL
INSPECT SUSPENSION CONTROL RELAY (AHC)
CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - RELAY BLOCK AND BODY GROUND)
DTC C1756 Suspension Control Relay Malfunction
DESCRIPTION
This relay is to supply the power source to the pump and motor. The relay stays on while the height control is operated.
| DTC Code | Detection Condition | Trouble Area |
| C1756 | When either of the following is detected: With the suspension control relay not activated, an open signal of the suspension control relay is detected for 1 second or more. With the suspension control relay activated, a short signal of the suspension control relay is detected 8 times successively. | Harness or connector Suspension control relay Suspension control ECU |
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
Before performing troubleshooting, inspect the connectors of related circuits.
If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed ().
| 1.INSPECT SUSPENSION CONTROL RELAY (AHC) |
Remove the suspension control relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 3 - 5 Battery voltage is not applied to terminal 1 and 2 10 kΩ or higher Battery voltage is applied to terminal 1 and 2 Below 1 Ω
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - RELAY BLOCK AND BODY GROUND) |
Remove the suspension control relay from the engine room relay block.
Disconnect the K36 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition K36-16 (RC) - Relay block suspension control relay terminal 1 Always Below 1 Ω K36-16 (RC) - Body ground Always 10 kΩ or higher Relay block suspension control relay terminal 2 - Body ground Always Below 1 Ω
|
| ||||
| OK | ||
| ||