ACTIVE HEIGHT CONTROL PUMP AND MOTOR - REMOVAL

1. DISCHARGE SUSPENSION FLUID PRESSURE

Connect a hose to the bleeder plug for the height control accumulator and loosen the bleeder plug.

Discharge the suspension fluid pressure.

After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.

2. REMOVE REAR QUARTER PANEL MUDGUARD RH

Remove the clip.

Using a T30 "TORX" socket, remove the 7 screws and mudguard.

3. REMOVE REAR BUMPER COVER

for Standard:

Remove the bumper cover ().

w/ Towing Hitch:

Remove the bumper cover ().

w/ Pintle Hook:

Remove the bumper cover ().

for Double Swing Out Type:

Remove the bumper cover ().

4. REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

Remove the 2 screws, 2 grommets and protector.

5. REMOVE FUEL TANK FILLER PIPE PROTECTOR

Using a T30 "TORX" socket wrench, remove the 3 screws, grommet and pipe protector.

6. DISCONNECT REAR NO. 6 HEIGHT CONTROL TUBE

Using a union nut wrench, disconnect the No. 6 height control tube from the pump and motor.

7. REMOVE HEIGHT CONTROL TUBE CLAMP

Disconnect the tube clamp from the hose, then remove the 2 bolts and tube clamp.

8. REMOVE HEIGHT CONTROL PUMP AND MOTOR ASSEMBLY

Disconnect the 2 connectors and 3 clamps.

Remove the 3 bolts and pump and motor.

Active Height Control Pump And Motor - Removal