Power Steering System (For 1Vd-Ftv With Dpf) - Ig Power Source Circuit

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - POWER ASSIST SYSTEMS

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)

POWER STEERING SYSTEM (for 1VD-FTV with DPF) - IG Power Source Circuit

DESCRIPTION

When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the power steering ECU.


WIRING DIAGRAM

Power Steering System (For 1Vd-Ftv With Dpf) - Ig Power Source Circuit. POWER ASSIST SYSTEMS. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

INSPECTION PROCEDURE

  • NOTICE:
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)
Power Steering System (For 1Vd-Ftv With Dpf) - Ig Power Source Circuit. POWER ASSIST SYSTEMS. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Disconnect the power steering ECU connector.

Measure the voltage according to the value(s) in the table below.

  • Standard Voltage:
  • Tester ConnectionSwitch ConditionSpecified Condition
    E102-5 (IG) - Body groundEngine switch on (IG)11 to 14 V

Measure the resistance according to the value(s) in the table below.

  • Standard Resistance:
  • Tester ConnectionConditionSpecified Condition
    E102-3 (GND) - Body groundAlwaysBelow 1 Ω
Text in Illustration
*aFront view of wire harness connector
(to Power Steering ECU)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE ()