Turbo Motor Driver - Removal

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV INTAKE / EXHAUST

TURBO MOTOR DRIVER - REMOVAL

1. PRECAUTION
  • NOTICE:
  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  • NOTICE:
  • When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Remove the 3 bolts and 2 screws.

Loosen the clip and remove the front fender splash shield RH.

4. REMOVE FRONT FENDER LINER RH

Remove the screw and disconnect the liner from the front bumper cover.

Using a T30 "TORX" socket, remove the 3 screws.

Remove the 5 clips.

  • HINT:
  • It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.
5. REMOVE TURBO MOTOR DRIVER
Turbo Motor Driver - Removal. 1VD-FTV INTAKE / EXHAUST. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Disconnect the connector.

Text in Illustration
*aClaw

Disconnect the connector as follows: (1) push the claw upward, and (2) move the lock lever to release the lock.

Turbo Motor Driver - Removal. 1VD-FTV INTAKE / EXHAUST. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Remove the 2 nuts, bolt and turbo motor driver.

  • NOTICE:
  • If the turbo motor driver has been struck or dropped, replace it.