Turbo Motor Driver - Installation

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV INTAKE / EXHAUST

TURBO MOTOR DRIVER - INSTALLATION

1. INSTALL TURBO MOTOR DRIVER
Turbo Motor Driver - Installation. 1VD-FTV INTAKE / EXHAUST. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Insert the bracket tab into the slot labeled A and insert the 2 stud bolts into the bracket as shown in illustration.

  • NOTICE:
  • If the turbo motor driver has been struck or dropped, replace it.

Install the 2 nuts and bolt.

  • Torque:
  • 20 N*m{ 199 kgf*cm, 14 ft.*lbf}
Turbo Motor Driver - Installation. 1VD-FTV INTAKE / EXHAUST. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Connect the connector. Then move the lock lever as shown in the illustration to lock the connector.

2. INSTALL FRONT FENDER LINER RH

Install the fender liner with the 5 clips.

Using a T30 "TORX" socket, install the 3 screws.

Connect the liner to the front bumper cover with the screw.

3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Install the front fender splash shield RH with the clip, and then install the 3 bolts and 2 screws.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  • NOTICE:
  • When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().