Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1GR-FE STARTING
RELAY - ON-VEHICLE INSPECTION
| 1. INSPECT STARTER RELAY (ST) |
for GRJ200L-GNANKC:
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher Battery voltage applied to terminals 1 and 2 Below 1 Ω
If the result is not as specified, replace the starter relay.
except GRJ200L-GNANKC:
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher Battery voltage applied to terminals 1 and 2 Below 1 Ω
If the result is not as specified, replace the starter relay.
| 2. INSPECT STARTER CUT RELAY (ST CUT) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher Battery voltage applied to terminals 1 and 2 Below 1 Ω
If the result is not as specified, replace the relay.
| 3. INSPECT MAIN BODY ECU (ACC RELAY) |
Measure the resistance of the ACC relay circuit.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 2A-1 - 2D-8 Battery voltage not applied between 2D-45 and 2D-62 10 kΩ or higher Battery voltage applied between 2D-45 and 2D-62 Below 1 Ω
If the result is not as specified, replace the main body ECU.