PURGE VALVE - INSPECTION

1. INSPECT PURGE VSV

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - VSV body ground Always 10 kΩ or higher
2 - VSV body ground 10 kΩ or higher

If the result is not as specified, replace the purge VSV.

Check the operation of the purge VSV.

Check that air does not flow from port F when air is applied to port E.

Text in Illustration
*a	Does not flow
	Air

Apply battery voltage to the connector, and check the VSV operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2 Air flows from port E to port F

Text in Illustration
	Air

If the result is not as specified, replace the purge VSV.

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2	Air flows from port E to port F

Purge Valve - Inspection