Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV LUBRICATION
OIL LEVEL SENSOR - REMOVAL
| 1. REMOVE FRONT WHEEL RH |
| 2. REMOVE FRONT FENDER APRON SEAL FRONT RH |
Remove the 3 clips and front fender apron seal front RH.
| 3. REMOVE FRONT FENDER APRON SEAL REAR RH |
Remove the 4 clips and front fender apron seal rear RH.
| 4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
Remove the 3 bolts and screw.
Loosen the clip and remove the front fender splash shield LH.
| 5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Remove the 3 bolts and 2 screws.
Loosen the clip and remove the front fender splash shield RH.
| 6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 10 bolts and No. 1 engine under cover.
| 7. DRAIN ENGINE OIL |
Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
- Torque:
- 38 N*m{ 387 kgf*cm, 28 ft.*lbf}
| 8. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 2 bolts and No. 2 engine under cover.
| 9. DISCONNECT OIL COOLER TUBE (for Automatic Transmission) |
Remove the 3 bolts and disconnect the oil cooler tube from the engine.
| 10. REMOVE ENGINE OIL LEVEL SENSOR |
Disconnect the sensor connector.
Remove the 4 bolts and sensor.
Remove the gasket from the sensor.