Fuel Sender Gauge Assembly (For Fuel Sub Tank) - Installation

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE FUEL

FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) - INSTALLATION

1. INSTALL FUEL SENDER GAUGE ASSEMBLY

Install a new gasket to the sender gauge.

Install the sender gauge with the 5 screws.

  • Torque:
  • 1.5 N*m{ 15 kgf*cm, 13 in.*lbf}
  • NOTICE:
  • Be careful not to bend the arm of the fuel sender gauge.

Connect the sender gauge connector.

2. INSTALL REAR FLOOR SERVICE HOLE COVER

Install the service hole cover with new butyl tape.

3. INSTALL REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)
Fuel Sender Gauge Assembly (For Fuel Sub Tank) - Installation. 1UR-FE FUEL. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Attach the 4 clips to install the air duct.

  • HINT:
  • Attach the clips in the order shown in the illustration.
4. INSTALL REAR FLOOR MAT ASSEMBLY

Attach the 5 clips to install the floor mat.

5. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
w/ Sliding Roof ()
w/o Sliding Roof ()
6. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
w/ Sliding Roof ()
w/o Sliding Roof ()
7. REMOVE REAR NO. 2 SEAT ASSEMBLY
for Face to Face Seat Type ()
except Face to Face Seat Type ()
8. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

()


9. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

()


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  • NOTICE:
  • When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().