Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1GR-FE ENGINE CONTROL
ECM - REMOVAL
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. DISCONNECT CONNECTOR HOLDER BLOCK |
Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
| *A | for LHD |
| *B | for RHD |
| 4. REMOVE ECM |
Raise the 2 levers while pushing the locks on the 2 levers.
| *1 | Lock |
| *a | Push |
- NOTICE:
- Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.
Disconnect the 2 connectors.
Remove the 4 bolts and ECM.
| 5. REMOVE GASKET |
Peel off the gasket.
Spray gasket remover or equivalent on the remaining tape of the gasket.
| *1 | Cloth |
- NOTICE:
- When using gasket remover or equivalent, cover the ECM connectors with a cloth.
Remove the tape of the gasket without using bladed objects.