Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV EMISSION CONTROL
DPF SWITCH (for DPF) - INSPECTION
1. INSPECT DPF SWITCH ASSEMBLY |

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Switch Condition Specified Condition 1 - 4 Switch OFF 10 kΩ or higher 1 - 4 Switch ON Below 1 Ω
If the result is not as specified, replace the DPF switch assembly.
Apply battery voltage to the switch connector and check that the DPF switch illuminates.
- OK:
Measurement Condition Specified Condition Apply battery voltage to terminal 3 (+) and 2 (-) Mark illumination illuminates
If the result is not as specified, replace the DPF switch assembly.