Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AXLE AND DIFFERENTIAL
REAR DIFFERENTIAL CARRIER ASSEMBLY (for LSD) - REMOVAL
| 1. DRAIN DIFFERENTIAL OIL |
Stop the vehicle on a level place.
for Front Differential:
Remove the engine under cover.
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
- Torque:
- 39 N*m{ 400 kgf*cm, 29 ft.*lbf}
for Rear Differential:
Remove the filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 49 N*m{ 500 kgf*cm, 36 ft.*lbf}
| 2. REMOVE REAR AXLE SHAFT |
Remove the axle shaft ().
| 3. DISCONNECT PROPELLER SHAFT ASSEMBLY |
Place matchmarks on the rear propeller shaft and companion flange.
Remove the 4 nuts, 4 washers and 4 bolts, and disconnect the propeller shaft from the differential side.
Support the propeller shaft securely.
| 4. REMOVE REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY |
Remove the 10 nuts, 10 washers and differential carrier.
- NOTICE:
- Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.
Remove the gasket.