Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AB60F AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM (for 1VD-FTV) - MONITOR DRIVE PATTERN
| AUTOMATIC TRANSMISSION MONITOR DRIVE PATTERN |
- CAUTION:
- Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.
- HINT:
- Performing this drive pattern is one method to simulate the automatic transmission malfunction detection conditions.
- The DTCs may not be stored through ordinary, everyday driving. Also, DTCs may not be stored through this drive pattern.
Preparation for driving
Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).
Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.
Malfunctions are not detected when the atmospheric temperature is below -10°C (14°F).
Drive pattern
Drive the vehicle through all the gears.
Stop → 1st → 2nd → 3rd → 4th → 5th → 5th (lock-up ON) → 6th → 6th (lock-up ON).
Repeat the above drive pattern 3 times or more.
- NOTICE:
When using the intelligent tester, the monitor status can be checked in the Data List ().
In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.
- HINT:
- *: Drive at such a speed in the uppermost gear to engage lock-up. The vehicle can be driven at a speed lower than the speed shown in the above diagram under the lock-up condition.
- NOTICE:
- It is necessary to drive the vehicle for approximately 30 minutes to store DTC P0711 (No. 1 ATF temperature sensor malfunction).