Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AB60F AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM (for 1UR-FE) - MANUAL SHIFTING TEST
| MANUAL SHIFTING TEST |
- HINT:
Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.
If any abnormalities are found in the following test, the problem is in the transmission itself.
Disconnect the connector of the No. 1 transmission wire and/or No. 2 transmission wire.
- HINT:
- It is possible to deactivate the electrical shift control by disconnecting the transmission wires. The gear positions can then be changed mechanically with the shift lever.
| *1 | No. 1 Transmission Wire |
| *2 | No. 2 Transmission Wire |
Drive the vehicle with the transmission wires disconnected. Move the shift lever to each position and check whether the gear position changes as shown in the table below.
| Shift Lever Position | Gear Position |
| P | P |
| R | R |
| D | 4th*1 1st to 6th*2 |
- HINT:
*1: When disconnecting only the No. 1 transmission wire or the No. 1 and No. 2 transmission wires.
*2: When disconnecting only the No. 2 transmission wire.
Connect the connector of the No. 1 transmission wire and/or No. 2 transmission wire.
Clear the DTCs ().