Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - A750F AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE) - HYDRAULIC TEST
| PERFORM HYDRAULIC TEST |
Measure the line pressure.
- CAUTION:
- The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stoppers outside the vehicle while the other is performing the test.
- NOTICE:
Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80°C (122 to 176°F).
Be careful to prevent SST hose from interfering with the exhaust pipe.
This check must be conducted after checking and adjusting the engine.
Perform the check with the A/C turned off.
When conducting the stall test, do not continue for more than 5 seconds.
Warm up the ATF (Automatic Transmission Fluid).
Turn the engine switch off.
Lift the vehicle up.
Remove the test plug on the transmission case center right side and connect SST.
- SST
- 09992-00095(09992-00231,09992-00271)
Lower the vehicle.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.
Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches stall speed.
In the same manner, perform the test with the shift lever in R.
| Condition | D Position | R Position |
| Stall test | 1360 to 1480 kPa (13.9 to 15.1 kgf/cm2, 197 to 215 psi) | 1290 to 1520 kPa (13.2 to 15.5 kgf/cm2, 187 to 220 psi) |
| Problem | Possible Cause |
| Measured values at D and R positions are higher than specified pressure | Shift solenoid valve SLT defective Regulator valve defective |
| Measured values at D and R positions are lower than specified pressure | Shift solenoid valve SLT defective Regulator valve defective Oil pump defective |
| Pressure is low in D position only | D position circuit fluid leak Clutch No. 1 (C1) defective |
| Pressure is low in R position only | R position circuit fluid leak Clutch No. 3 (C3) defective Brake No. 4 (B4) defective |