Rear Seat Entertainment System - How To Proceed With Troubleshooting

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AUDIO / VIDEO


REAR SEAT ENTERTAINMENT SYSTEM - HOW TO PROCEED WITH TROUBLESHOOTING

  • HINT:
Use the following procedure to troubleshoot the rear seat entertainment system.
*: Use the intelligent tester.

1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE

Inspect the battery voltage.

  • Standard voltage:
  • 11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to next step.


NEXT
3.CHECK FOR DTC*

Refer to DTC Check / Clear ().

Result
ResultProceed to
DTC is output.A
DTC is not output.B
  • HINT:
  • If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the intelligent tester ().
B.
Go to step 7
A
4.CLEAR DTC*

Clear the DTCs and finish diagnostic mode.

  • HINT:
  • The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.
NEXT
5.RECHECK FOR DTC*

Recheck for DTCs.

Result
ResultProceed to
DTC is output.A
DTC is not output.B
  • HINT:
Even if the malfunction symptom cannot be confirmed, check for DTCs. This is because the system stores history DTCs.
If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the intelligent tester ().
Check the DTC and inspect the area the code indicates.
B.
Go to step 7
A
6.DIAGNOSTIC TROUBLE CODE CHART

Find the output code in the diagnostic trouble code chart ().

  • NOTICE:
The rear seat entertainment system outputs DTCs for the following system.
When DTCs other than those in Diagnostic Trouble Code Chart for the rear seat entertainment system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
Refer to Navigation System ()
Refer to Audio and Visual System (w/ Navigation System) ()
Result
ResultProceed to
DTCs for the rear seat entertainment system are output.A
DTCs for the navigation system are output.B
DTCs for the audio and visual system (w/ Navigation System) are output.C
A.
Go to step 9
B.
GO TO NAVIGATION SYSTEM ()
C.
GO TO AUDIO AND VISUAL SYSTEM ()
7.PROBLEM SYMPTOMS TABLE

Refer to Problem Symptoms Table ().

Result
ResultProceed to
Fault is not listed in Problem Symptoms Table.A
Fault is listed in Problem Symptoms Table.B
  • HINT:
  • If the symptom does not recur and no DTC is output, perform the symptom simulation method ().
B.
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
A
8.CHECK ECU TERMINAL ARRANGEMENT BASED ON MALFUNCTION SYMPTOM

Refer to Terminals of ECU ().

NEXT
9.CHECK CIRCUIT

Adjust, repair or replace as necessary.

NEXT
10.RECHECK FOR DIAGNOSTIC TROUBLE CODE*
  • HINT:
  • After clearing the DTCs, recheck for DTCs.
NEXT
11.PERFORM CONFIRMATION TEST
NEXT
END