Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AUDIO / VIDEO
RADIO RECEIVER (w/ Multi-display) - REMOVAL
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
Put protective tape around the No. 2 instrument panel finish panel cushion.
| *1 | Protective Tape |
Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.
| 4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH |
Remove the clip and screw.
Detach the 8 claws.
Disconnect the connectors, detach the 2 clamps and remove the lower instrument panel pad sub-assembly.
| 5. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION |
Put protective tape around the No. 1 instrument panel finish panel cushion.
| *1 | Protective Tape |
Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.
| 6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH |
Remove the clip and screw.
Detach the 7 claws and remove the lower instrument panel pad sub-assembly.
| 7. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
Detach the 7 claws.
Disconnect the connectors and remove the lower center instrument cluster finish panel sub-assembly.
| 8. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY |
Detach the 8 claws and remove the opening cover.
| 9. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY |
Place protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover, detach the 6 claws.
Disconnect the connector and remove the No. 3 instrument panel register.
| 10. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY |
Place protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover, detach the 6 claws.
Disconnect the connector and remove the No. 4 instrument panel register.
| 11. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET |
Remove the 2 screws and 2 bolts.
Pull the multi-display assembly to detach the 2 clips and 6 claws on the backside of the multi-display assembly.
Disconnect the connectors and remove the multi-display assembly.
| 12. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET |
Remove the 2 screws and 2 bolts.
Pull the multi-media module receiver assembly to detach the 5 claws on the backside of the multi-media module receiver assembly.
Disconnect the connectors and remove the multi-media module receiver assembly.
| 13. REMOVE NO. 1 RADIO BRACKET |
Remove the 3 bolts and No. 1 radio bracket.
| 14. REMOVE NO. 2 RADIO BRACKET |
Remove the 3 bolts and No. 2 radio bracket.