Diagnostic trouble code C0226 C0236 C0246 C0256 C1225 C1226 C1227 C1228 Land Cruiser

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

RECONFIRM DTC

DTC C0226/21 SFR Solenoid Circuit

DTC C0236/22 SFL Solenoid Circuit

DTC C0246/23 SRR Solenoid Circuit

DTC C0256/24 SRL Solenoid Circuit

DTC C1225/25 SMC Solenoid Circuit

DTC C1226/26 SPC Solenoid Circuit

DTC C1227/27 SRC Solenoid Circuit

DTC C1228/28 STR Solenoid Circuit

Description

The solenoid turns on when signals are received from the ECU and controls the pressure acting on the wheel cylinders, thus controlling braking force.

DTC Code DTC Detection Condition Trouble Area
C0226/21 An open or short circuit in the SFRH or SFRR circuit continues for 0.05 seconds or more.
  1. SFRH or SFRR circuit
  2. Master cylinder solenoid
C0236/22 An open or short circuit in the SFLH or SFLR circuit continues for 0.05 seconds or more.
  1. SFLH or SFLR circuit
  2. Master cylinder solenoid
C0246/23 An open or short circuit in the SRRH or SRRR circuit continues for 0.05 seconds or more.
  1. SRRH or SRRR circuit
  2. Master cylinder solenoid
C0256/24 An open or short circuit in the SRLH or SRLR circuit continues for 0.05 seconds or more.
  1. SRLH or SRLR circuit
  2. Master cylinder solenoid
C1225/25 An open or short circuit in the SMCF circuit continues for 0.05 seconds or more.
  1. SMCF circuit
  2. Master cylinder solenoid
C1226/26 An open or short circuit in the SREA circuit continues for 0.05 seconds or more.
  1. SREA circuit
  2. Master cylinder solenoid
C1227/27 An open or short circuit in the SREC circuit continues for 0.05 seconds or more.
  1. SREC circuit
  2. Master cylinder solenoid
C1228/28 An open or short circuit in the STR circuit continues for 0.05 seconds or more.
  1. STR circuit
  2. Master cylinder solenoid

Wiring diagram

Diagnostic trouble code C0226 C0236 C0246 C0256 C1225 C1226 C1227 C1228 Land Cruiser. Wiring diagram

Inspection procedure

NOTICE:

When replacing the master cylinder solenoid, perform zero point calibration .

1.RECONFIRM DTC

HINT:

These codes are stored when a problem is detected in the master cylinder solenoid.

The solenoid circuit is in the master cylinder solenoid.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

  1. Clear the DTCs .

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output .

    Result
    Result Proceed to
    DTC is not output A
    DTC is output LHD B
    RHD C
  B  
REPLACE MASTER CYLINDER SOLENOID
 
  C  
REPLACE MASTER CYLINDER SOLENOID
 
A  
   
USE SIMULATION METHOD TO CHECK