1. INSTALL REAR CRANKSHAFT OIL SEAL |
-
Apply MP grease to the lip of a new oil seal.
-
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST
09223-56010
NOTICE:
- Keep the lip free from foreign matter.
- Do not tap on the oil seal at an angle.
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
-
Using SST, hold the crankshaft.
SST
09213-70011 09330-00021
-
Install the crankshaft angle sensor rotor.
Text in Illustration Engine Side HINT:
- Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.
- As the crankshaft angle sensor rotor is not reversible, be sure to install it so that it is facing in the direction shown in the illustration.
-
Install the drive plate and rear drive plate spacer onto the crankshaft.
Text in Illustration *1 Drive Plate *2 Rear Drive Plate Spacer Automatic Transmission Side HINT:
As the rear drive plate spacer and the drive plate are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.
-
Install the drive plate and ring gear and bolts.
HINT:
The bolts are tightened in 2 progressive steps.
-
Clean the bolts and bolt holes.
-
Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Text in Illustration *1 Adhesive -
Step 1:
Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.
Torque:
30 N*m{ 301 kgf*cm , 22 ft.*lbf }
NOTICE:
- Do not reuse the drive plate installation bolts.
- Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.
-
Mark the upside of each drive plate installation bolt with paint.
-
Step 2:
Tighten the cylinder head bolts another 90°.
-
Check that the painted marks are now at a 90° angle to the upside.
NOTICE:
Do not start the engine for at least an hour after installing the drive plate.
-
3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY |
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected .