Промежуточный Вал Разборка. Corolla ZZE150

Using a screwdriver, remove the snap ring.

Remove the flange, 3 discs and 3 plates.

Using a screwdriver, remove the snap ring.

Remove the direct clutch flange, 3 direct clutch discs and 3 rear clutch flanges.

Using SST and a press, remove the snap ring.

SST

09387-00020

Remove the direct clutch return spring sub-assembly from the intermediate shaft.

Install the intermediate shaft onto the transaxle rear cover.

Apply compressed air (392 kPa, 4.0 kgf/cm², 57 psi) to the oil hole shown in the illustration and remove the direct clutch piston from the intermediate shaft.

ПРИМЕЧАНИЕ:

1. Blowing the air may cause the piston to jump out. When removing the piston, hold it by hand using a shop rag or piece of cloth.
   
2. Do not splash ATF with the compressed air.
   

Install the intermediate shaft onto the transaxle rear cover.

Put a matchmark on the direct clutch drum in the same position as the cutout of the intermediate shaft assembly.

Apply compressed air (392 kPa, 4.0 kgf/cm², 57 psi) to the oil hole shown in the illustration and remove the direct clutch drum from the intermediate shaft.

ПРИМЕЧАНИЕ:

1. Blowing the air may cause the drum to jump out. When removing the drum, hold it by hand using a shop rag or piece of cloth.
   
2. Do not splash ATF with the compressed air.
   

Using a screwdriver, remove the 2 piston O-rings from the direct clutch piston.

Using a screwdriver, remove the direct clutch drum O-ring from the direct clutch drum.