Корпус Дроссельной Заслонки Дизельного Двигателя Установка. Corolla Auris

Install a new gasket and the diesel throttle body with the 2 nuts and 2 bolts.

Момент затяжки:

21 Н*м{214 кгс*см, 15 фунт-сила-футов}

Connect the throttle position sensor connector.

Connect the throttle motor connector.

Insert the No. 4 air hose to the diesel throttle body.

Insert the No. 2 air tube to the No. 4 air hose as described below.

1. Align the embossed mark of the No. 2 air tube within the paint mark of the No. 4 air hose.
   





2. Temporarily install the 2 hose clamps.
   

   ПРИМЕЧАНИЕ:

   Each hose clamp should be installed so that the paint mark can be seen on either side of the clamp band as shown in the illustration.

Install the No. 2 air tube with the bolt.

Момент затяжки:

48 Н*м{489 кгс*см, 35 фунт-сила-футов}

Tighten the 2 hose clamps.

Момент затяжки:

6.3 Н*м{64 кгс*см, 56 фунт-сила-дюймов}

Connect the sensor connector.

Install the No. 3 air hose.

1. Tighten the hose clamp.
   

   Момент затяжки:

   6.3 Н*м{64 кгс*см, 56 фунт-сила-дюймов}

2. Connect the No. 3 air hose to the intercooler.
   

   ПРИМЕЧАНИЕ:

   1. Check that the retainer is closed when the connector is inserted.
      
   2. If replacing or reusing the hose, check for deposits in the intercooler and air hose. If necessary, wipe off the deposits.
      
   3. If replacing or reusing the hose, apply fresh oil to the O-ring.
      
   4. The connectors should be inserted until a clinking sound indicating that they are completely connected is heard. Then, check that the connectors cannot be disconnected by pulling on them.
      
   5. Do not use a quick connector that has been dropped.
      

Connect the 2 vacuum transmitting hoses to the No. 2 air tube.

Install the vacuum transmitting hose to the 3 clamps.

Attach the 4 clips to install the engine cover.