INSTALL TRANSMISSION VALVE BODY ASSEMBLY

CONNECT TRANSMISSION WIRE

INSTALL VALVE BODY OIL STRAINER ASSEMBLY

INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

ADD AUTOMATIC TRANSMISSION FLUID

RESET MEMORY

PERFORM INITIALIZATION

Install the check ball body and spring.

Check the accumulator pistons, check ball body and spring as shown in the illustration.

Align the groove of the manual valve with the pin of the lever.

Install the 19 bolts.

• Torque:
• 11 N*m{ 112 kgf*cm, 8 ft.*lbf}

• Bolt length:
• Bolt A:
• 25 mm (0.98 in.)
• Bolt B:
• 36 mm (1.42 in.)
• Bolt C:
• 45 mm (1.77 in.)
• Bolt D:
• 50 mm (1.97 in.)

Connect the 9 connectors to the solenoid valves.

Install the ATF temperature sensor with the bolt.

• Torque:
• 10 N*m{ 102 kgf*cm, 7 ft.*lbf}

Install the 2 clamps with the 2 bolts.

• Torque:
• Bolt A:
• 6.4 N*m{ 65 kgf*cm, 57 in.*lbf}
• Bolt B:
• 10 N*m{ 102 kgf*cm, 7 ft.*lbf}

Coat a new O-ring with ATF.

Install the O-ring.

Install the oil strainer with the 4 bolts.

• Torque:
• 10 N*m{ 102 kgf*cm, 7 ft.*lbf}

Install the 3 magnets in the oil pan.

Install a new gasket and the oil pan to the transmission case with the 20 bolts.

• Torque:
• 4.4 N*m{ 45 kgf*cm, 39 in.*lbf}

Install the No. 1 exhaust pipe support bracket sub-assembly to the automatic transmission assembly with the 2 bolts.

• Torque:
• 43 N*m{ 438 kgf*cm, 32 ft.*lbf}