INSTALL FRONT AXLE HUB SUB-ASSEMBLY

INSPECT FRONT AXLE HUB BEARING FOR LOOSENESS

INSPECT FRONT AXLE HUB FOR RUNOUT

INSTALL FRONT DISC

INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

CONNECT FRONT SPEED SENSOR

INSTALL FRONT WHEEL

CHECK ABS SPEED SENSOR SIGNAL

Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.

• Torque:
• 69 N*m{ 702 kgf*cm, 51 ft.*lbf}

Using a dial indicator, check for looseness near the center of the axle hub.

• Maximum:
• 0.05 mm (0.0020 in.)

• NOTICE:

• Ensure that the dial indicator is perpendicular to the measurement surface.

If looseness exceeds the maximum, replace the front axle hub.

Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

• Maximum:
• 0.05 mm (0.0020 in.)

• NOTICE:

• Ensure that the dial indicator is set perpendicular to the measurement surface.

If runout exceeds the maximum, replace the front axle hub.

Align the matchmarks and install the front disc.

• HINT:

• When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.

Install the brake caliper assembly and new No. 1 caliper plates to the steering knuckle with the 2 bolts.

• Torque:
• 78 N*m{ 795 kgf*cm, 58 ft.*lbf}

• NOTICE:

Connect the speed sensor connector to the seed sensor front.

• NOTICE:

• Do not twist the sensor wire.