FIX POWER STEERING GEAR ASSEMBLY

REMOVE TIE ROD END LH

REMOVE TIE ROD END RH

REMOVE STEERING RACK BOOT CLIP

REMOVE NO. 1 STEERING RACK BOOT CLAMP

REMOVE NO. 1 STEERING RACK BOOT

REMOVE STEERING RACK END SUB-ASSEMBLY

Using SST, secure the power steering gear assembly.

• SST
• 09612-00012

• HINT:

• Tape the SST before use.

Put matchmarks on the tie rod end LH and the steering rack end sub-assembly.

Loosen the lock nut, and remove the tie rod end LH and the lock nut.

Using pliers, remove the 2 steering rack boot clips.

Using pliers and a screwdriver, remove the No. 1 steering rack boot clamp (LH side) as shown in the illustration.

• NOTICE:

• Be careful not to damage the No. 1 steering rack boot.

Remove the RH side by using the same procedure as for the LH side.

Remove the 2 No. 1 steering rack boots.

Using a screwdriver and a hammer, unstake the RH and LH claw washers.

• NOTICE:

• Avoid any impact to the steering rack.

Using 2 SST, remove the steering rack end sub-assembly (LH side) and the claw washer.

• SST
• 09922-10010

• NOTICE:

• Use SST 09922-10010 following the direction shown in the illustration.

Using 2 SST, remove the steering rack end sub-assembly (RH side) and the claw washer.

• SST
• 09922-10010

• NOTICE:

• Use SST 09922-10010 following the direction shown in the illustration.

• HINT:

• Using SST, hold the rack and remove the steering rack end sub-assembly.