Lexus IS250 IS220d GSE20 ALE20 - THEFT DETERRENT
ENGINE HOOD COURTESY SWITCH - REMOVAL
| 1. REMOVE COOL AIR INTAKE DUCT SEAL |
Using a clip remover, remove the 11 clips and cool air intake duct seal.
| 2. REMOVE FRONT BUMPER ASSEMBLY |
Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
- HINT:
Put protective tape around the front bumper assembly.
Using a clip remover, remove the 2 clips
Remove the 2 radiator grille protectors.
Remove the bolt and 10 screws.
Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedures for the RH side and LH side.
Disconnect the headlight washer hose. (w/ headlight cleaner system)
Disconnect the connector and remove the front bumper assembly.
| 3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) |
Disconnect the connector.
Remove the 3 bolts and the millimeter wave radar sensor assembly.
| 4. REMOVE LOW PITCHED HORN ASSEMBLY |
Disconnect the connector.
Remove the bolt and the low pitched horn.
| 5. REMOVE HOOD LOCK CONTROL CABLE COVER |
Remove the 3 screws.
Detach the claw and remove the hood lock control cable cover.
| 6. REMOVE HOOD LOCK ASSEMBLY |
Using a screwdriver, remove the hood lock nut cap as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Remove the 2 bolts and nut.
Disconnect the hood lock control cable and connector.
Remove the hood lock assembly.