INSTALL SPIRAL CABLE

INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

INSTALL STEERING COLUMN COVER

ADJUST SPIRAL CABLE WITH STEERING SENSOR

INSTALL STEERING WHEEL ASSEMBLY

INSPECT STEERING WHEEL CENTER POINT

INSTALL STEERING PAD

INSTALL LOWER NO. 3 STEERING WHEEL COVER

INSTALL LOWER NO. 2 STEERING WHEEL COVER

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

INSPECT STEERING PAD

PERFORM INITIALIZATION

INSPECT SRS WARNING LIGHT

Engage the 6 claws and install the spiral cable to the steering sensor.

Check that the front wheels are facing straight ahead.

Set the turn signal switch to the neutral position.

• NOTICE:

• If it is not in the neutral position, the pin of the turn signal switch may be snapped.

Engage the 3 claws and install the spiral cable with steering sensor.

• NOTICE:

• When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

Connect the connectors to the spiral cable with steering sensor.

• NOTICE:

• When handling the airbag connector, take care not to damage the airbag wire harness.

Check that the engine switch is off.

Check that the battery negative (-) terminal is disconnected.

• CAUTION:

• After removing the terminal, wait for at least 90 seconds before starting the operation.

Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.

• NOTICE:

• Do not turn the spiral cable with steering sensor by the airbag wire harness.

Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.

• NOTICE:

• Do not turn the spiral cable with spiral sensor by the airbag wire harness.

• HINT:

• The spiral cable with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.

Support the steering pad with one hand as shown in the illustration.

Connect the 2 connectors to the steering pad.

• NOTICE:

• When handling the airbag connector, take care not to damage the airbag wire harness.

Connect the horn connector.

Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

• Torque:
• 8.8 N*m{ 90 kgf*cm, 78 in.*lbf}

Install the steering wheel No.3 cover lower.

Install the steering wheel No.2 cover lower.

Inspect the steering pad .

Perform initialization .

• HINT:

• Some systems need initialization after reconnecting the cable to the negative battery terminal.

Inspect the SRS warning light .