Lexus IS250 IS220d GSE20 ALE20 - PRE-CRASH SAFETY
INSPECT FRONT SEAT OUTER BELT ASSEMBLY RH
CHECK HARNESS AND CONNECTOR (FRONT SEAT BELT ASSEMBLY RH - SEAT BELT CONTROL ECU)
DTC B2035 Power Supply Relay Adherence Malfunction
DESCRIPTION
The DTC is output during the power supply relay adherence malfunction in the seat belt control ECU.
DTC No. | DTC Detection Condition | Trouble Area |
B2035 | Adherence in power supply relay | Wire harness Seat belt control ECU |
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- When the seat belt control ECU is replaced with a new one, INITIALIZATION must be performed .
1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY RH |
Disconnect the P8 connector of the front seat outer belt assembly RH.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection Condition Specified Condition P8-1 - Body ground Engine switch on (IG) Below 1 V P8-2 - Body ground Engine switch on (IG) Below 1 V
|
| ||||
OK | |
2.CHECK HARNESS AND CONNECTOR (FRONT SEAT BELT ASSEMBLY RH - SEAT BELT CONTROL ECU) |
Disconnect the negative (-) battery terminal .
Disconnect the O38 connector of the seat belt control ECU.
Connect the negative (-) terminal to the battery.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection Condition Specified Condition P8-1 - Body ground Engine switch on (IG) Below 1 V P8-2 - Body ground Engine switch on (IG) Below 1 V
|
| ||||
OK | |
3.CHECK DTC OUTPUT |
Turn the engine switch on (IG).
Clear the DTCs stored in memory .
Turn the engine switch off.
Turn the engine switch on (IG).
Check for the DTCs .
- OK:
- No DTC is output.
|
| ||||
OK | ||
|
LEXUS IS250, IS220d / GSE20 ALE20