Lexus IS250 IS220d GSE20 ALE20 - AIR CONDITIONING
AMBIENT TEMPERATURE SENSOR - REMOVAL
1. REMOVE COOL AIR INTAKE DUCT SEAL |
Using a clip remover, remove the 11 clips and cool air intake duct seal.
2. REMOVE FRONT BUMPER ASSEMBLY |
Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
- HINT:
Tape the screwdriver tip before use.
Use the same procedures for the RH side and LH side.
Put protective tape around the front bumper assembly.
Using a clip remover, remove the 2 clips
Remove the 2 radiator grille protectors.
Remove the bolt and 10 screws.
Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedures for the RH side and LH side.
Disconnect the headlight washer hose. (w/ headlight cleaner system)
Disconnect the connector and remove the front bumper assembly.
3. REMOVE AMBIENT TEMPERATURE SENSOR |
Disconnect the connector and detach the clamp.
Remove the ambient temperature sensor.
LEXUS IS250, IS220d / GSE20 ALE20