Lexus IS250 IS220d GSE20 ALE20 - PROPELLER SHAFT
REAR PROPELLER SHAFT ASSEMBLY - REMOVAL
| 1. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR |
Remove the 4 nuts and front No. 1 floor heat insulator.
| 3. REMOVE OUTSIDE AIR GUIDE PLATE RH |
Remove the 4 nuts and outside air guide plate RH.
| 4. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY |
Put matchmarks on both flanges.
Remove the 4 nuts, bolts and washers.
- HINT:
- If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.
Remove the 2 bolts and 2 center support bearing washers. (for automatic transmission)
Remove the 2 bolts, 2 center support bearing washers and 2 center support bearing dampers. (for manual transmission)
Separate the center support bearing.
Insert SST in the transmission to prevent oil leakage.
- SST
- 09325-40010
- NOTICE:
- Be careful not to damage the oil seal.
LEXUS IS250, IS220d / GSE20 ALE20