Diagnostic trouble code P0116 4GR-FSE Engine

Description

Inspection procedure

CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)

INSPECT THERMOSTAT

DTC P0116 Engine Coolant Temperature Circuit Range / Performance Problem

Description

A thermistor is built into the Engine Coolant Temperature (ECT) sensor, of which the resistance value varies according to the ECT. The structure of the sensor and its connection to the ECM are the same as those of the Intake Air Temperature (IAT) sensor.  

DTC No. DTC Detection Condition Trouble Area
P0116 Case 1:
Engine Coolant Temperature (ECT) between 35°C and 60°C (95°F and 140°F) when engine started, and conditions (a) and (b) met (2 trip detection logic):
(a) Vehicle driven at varying speeds (accelerated and decelerated)
(b) ECT remains within 3°C (5.4°F) of initial ECT
Case 2:
ECT more than 60°C (140°F) when engine started, and conditions (a) and (b) met (6 trip detection logic):
(a) Vehicle driven at varying speeds (accelerated and decelerated)
(b) ECT measurements remain within 1°C (1.8°F) of initial ECT on 6 successive occasions
  1. Thermostat
  1. ECT sensor

Inspection procedure

HINT:

  1. If any of DTCs P0115, P0117, P0118 or P0125 are set simultaneously with DTC P0116, the ECT sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  2. Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred .

 

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the tester ON.

  1. Enter the following menus: Power train / Engine / DTC.

  1. Read the DTC.

    Result:

    Display (DTC output) Proceed to
    P0116 A
    P0116 and other DTCs B
  B  
GO TO DTC CHART
 
A  
   

2.INSPECT THERMOSTAT
  1. Remove the thermostat .

  1. Check the valve opening temperature of the thermostat.

    Standard:

    80 to 84°C (176 to 183°F)

    HINT:

    In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

  1. Reinstall the thermostat .

  NG  
REPLACE THERMOSTAT
 
OK  
   
REPLACE ENGINE COOLANT TEMPERATURE SENSOR